Is It Necessary For The Stainless Steel Vibrating Screen To Be Polished?

Normally, when the shaker material is 304 stainless steel, the equipment in the factory usually need to be polished before delivery. Different surface processing will make the stainless steel surface differences, such as food processing, pharmaceutical industry, health requirements are relatively high, in these applications, the vibrating screen surface must be smooth, smooth surface smooth vibrating screen, dirt deposition will lead to stainless steel Surface rust and even cause corrosion, so in these special industries require stainless steel shaker must be inside and outside the polishing.

In addition, there are some fine powder industry also need to be polished, after polishing, the surface of the sieve is not easy to contaminate the material powder, easy to clean, you can also filter other materials; other general industry usually only need to be polished You can, so polished after the appearance of good-looking, in the course of the use of the above will not be stabbed to the hand.

How does the vibrating screen appear to mix?

First check the vibration screen sieve frame and sieve body sealing degree. Vibrating screen sieve frame and the middle of the screen are sealed to seal. Commonly used seal material is natural rubber and silicone. Vibrating screen in the use of a period of time after the seal will appear deformation or rupture. Xiao Bian suggested that users in the use of vibrating screen should be regularly check the use of the seal, there should be timely replacement of damage.

Followed by the reasons for the broken screen. The screen of the vibrating screen is a wearing part, and the wear of the different sieving materials is different. In the continuous operation of the screen at the same time the load on the screen is quite large, it will cause damage to the screen, in the production process should be timely to find timely replacement. To ensure the quality of the sieving material.

Finally, the material on the screen surface of the operating trajectory, resulting in small particles and large particles of material can not be completely graded. Usually this situation is the problem of Vibrating Screen angle. General shaker in the factory when the motor angle is adjusted to 65 degrees, the use of the material according to the screening situation to adjust the motor angle. To change the running of the material on the screen surface. So that the screening accuracy improved.